Asphalt paving setup can be a rather labor-intensive task. Additionally, it can be complex if there are no specific phases, plus the prep phase is not finished correctly. If the area is not completely prepared and you try to lay the asphalt, it will not be permanent and smooth.
Click here for more information about DOW Asphalt Company Inc.
Image Source: Google
Mark the area
If you are experiencing a driveway, the starting point maybe with the garage or in the conclusion of what your driveway is going to be. Continue to point out the area using a tape measure around the perimeter outside the area. On every corner in the wooden part.
To make sure the location is symmetrical you can measure from one corner to another, mark the numbers, and then continue to execute all four corners or you can use a laser level. When you have typed the numbers down, it is square and you are ready for the second step.
Build a solid foundation
Dig the outside area to prepare it for asphalt and gravel. Place a chain from one wooden pole to another and dig up the area inside the chain to twenty inches. You want to get it as close as possible under twenty-five inches.
Use a gasoline-powered compactor to determine the location you dug and do not destroy the asphalt coating by compacting the entire space. If the area below is not flat and solid, the following will not be.
It is possible to use tiny bets around the outside edges to fasten the framework if you want too. As soon as you've got compacted down the ground, you can begin on the following step.
A coating of landscaping net is going to be stretched throughout the region and amounts of pea gravel is going to be placed down. Each layer is going to be leveled out with a shovel or rake and compacted before another level is placed down.
Asphalt paving installation
When pouring asphalt, the company will spread it around to ensure that the water is sloped properly to run. They will turn it down before it dries.